10 Best Rockville Amplifier Review Recommended By An Expert

Features :

• Includes: Amplifier. Birth sheet with tested power. Owner’s manual. Mounting Screws. Warranty.
• Features: Rockville dB45 3200 Watt/800 Watt Dyno-Certified RMS 4 Channel Amplifier Car Stereo Amp, Loud!!.
• Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc). – 2 Ohm: 200 Watts x 4 Channel
• Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc). – 2 Ohm: 800 Watts x 4 Channel. – 4 Ohm:540 Watts x 4 Channel. – 4 Ohm Bridged: 1600 Watts x 2 Channel. High-Speed MOSFET Power Supply. Under Voltage Protection at 10V. Over Voltage Protection at 16V. Tertiary Supplies Circuitry. Optical Coupler Class “AB” Technology. Studio-Grade Bipolar Output Stage Transistors.
• Fully Adjustable 12dB / Octave Crossover with Differential Circuitry. Low Pass Filter: 50Hz – 3KHz. High Pass Filter: 15Hz – 1KHz. Full IC-Controlled Protection Circuitry. Fully Adjustable 12dB Bass Equalizer. Mute and Delay Soft Start System. 8 Volt Preamp Circuitry. Status Mode LED Indicator. Minimum THD at Rated Power: 90dB. Frequency Response: 10Hz – 50KHz. Damping Factor: >150 @ 100Hz. 35 Amp*3 ATC Fuse. Dimensions: (W x H x L) 9″ x 2.4″ x 21.0″

Features :

• POWERED SUBWOOFER FOR EXTRA BASS & PUNCH – A 10-inch Dynamic Balance woofer & a uniquely configured directed port provides accurate bass with added depth that brings your music and movies alive. A perfect solution for your small-to-mid size room
• LOUDER CLEARER SOUND EVEN AT HIGH VOLUME – Enjoy a thrilling yet balanced music experience with rich, deep sound, even at low frequencies. BLENDS EASILY WITH ANY SPEAKER and plays the most demanding nodes effortlessly without any distortion
• DOUBLE THE AMPLIFIER POWER TO 100 Watts of Dynamic Power with its in-built 50-watt RMS amp. Sophisticated engineering with best in class resonance-free driver materials make this sub highly durable and FIT FOR EXTENDED USE
• EASY TO INTEGRATE WITH EXISTING SYSTEMS – Hook up this sub to the receiver and upgrade your music sound instantly. Features continuously variable 80-160 Hz crossover and 40-160 Hz (-3dB) frequency response
• A sleek detachable grille on the front, speaker and line-level inputs as well as speaker-level outputs on the back, and a Phase Toggle Switch for multiple subwoofers, make this sub cohesive and complete

Features :

• Rockville ATOM 8W 8 Channel 3500 Watt Peak / 880w Dyno-Certified RMS Marine/Boat Amplifier Amp w/Bluetooth
• Compact design and extremely high power (Do not be fooled by the compact size; this amp is a beast!!!); Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc); 3500 Watts Peak System Power
• Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc); RMS Power Output at 4 Ohms: 70 Watts x 8 Channels
• RMS Power Output at 2 Ohms: 110 Watts x 8 Channels. RMS Bridged Power Output at 4 Ohms: 220 Watts x 4 Channels. Voltage display on amp; Configurable to 8, 6, or 4 channels
• Bluetooth Wireless with Auto Pairing. RCA Line Output. UV and Salt Water Resistant Paint, Silk Screen and Heat Sink Enclosure; 80A Fuse rating; Marine-Grade Conformal Coated Boards Resist Corrosion from Salt Spray and Moisture

Features :

• KILLER AUDIO: With crystal highs, crisp mids and rich bass, XSound Go creates an immersive listening experience unlike any other. State of the art bass radiators and dual 8W power drivers deliver shocking sound without distortion even at maximum volume.
• EXTREME WATERPROOFING: Pool parties? Definitely. Lounging on the beach? Absolutely. Singing in the shower? You bet! This waterproof speaker is perfect for all sorts of summer fun.
• SLEEK & SOPHISTICATED: Tribit XSound Go is as stylish as they come. Curved edges and a matte finish offer a modern touch, the compact design maximizes portability. Toss it in a backpack, stick in in your purse, or carry it around with the attached strap.
• ALL DAY PLAY: Keep the music pumping all day (and all night) long. The powerful battery guarantees up to 24 hours of continuous use! You’ll be able to enjoy your favorite songs whenever (and wherever) you please.
• WIRELESS CONNECTION: Don’t let cords tie you down. Premium bluetooth 5.0 technology effortlessly connects to all of your bluetooth-enabled devices up to 100ft range. Press and hold the multifunction button to access the voice input for Siri and Google Now.

Features :

• Rockville RCS350-6 350 Watt 6 zone 70V commercial/restaurant amplifier/Bluetooth
• Rockville RCS350-6 350 Watt commercial/restaurant amplifier 19″ Rack mountable (removable rack brackets) digital hybrid amplifier/receiver Capable of 70 volt 100 Volt 8 ohm and 4 ohm 70/100 volt RMS power 184 watts 6-Zones – each zone has a separate volume control Built in Bluetooth Audio streaming Fm radio tuner Usb input to play audio stored on a thumb drive (32GB max)
• Sd card slot to play music stored on an SD card (32GB max) separate volume control for Mic1 Mic2 Mic3 MP3 line1 line 2 and MP3 Echo control for the mic inputs with speed and repeat adjustments Built in clipping limiter to protect the amp and speakers Bass and treble control. Detachable euro-block speaker output terminals for easy installation. Chime button for making announcements Top quality aluminum panel with industrial grade knobs 5 segments signal level indication
• (2) sets RCA aux inputs (3) mic inputs Rca line output 100V speaker red positive speaker output terminal 70V speaker red positive speaker output terminal 8 ohm red positive speaker output terminal Shared negative speaker output terminal
• Power requirements 120V/ 50-60Hz A weighted signal to noise (@ 1W) -68 1Dba A weighted signal to noise (referenced to full 4 ohm power) -89 2Dba Frequency response 49Hz to 14 9 kHz Frequency response VS thd+m (worst case across normal bandwidth 1W @ 8 ohms 0 89% weight 22 7lbs Dimensions 19” x 16” x 4” inches
• Applications restaurant Bar Café School Lounge Home (multi-zone multi-room) office Warehouse
• Included components: Quick Start Guide

Features :

• Includes: Amplifier. PA Microphone. Bass Remote. Mounting Screws
• Features: Rockville RXM-S6 Marine/Boat 6 Channel Amplifier 2600 Watt Peak / 660w Dyno-Certified RMS With Status Mode LED Indicator. Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc). 420 Watts (6 x 70 Watts) at 4 ohms and 1% THD+N. 660 Watts (6 x 110 Watts) at 2 ohms
• Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc): 2600 Watts (6 x 440 @ 2 ohms or 3 x 880 @ 4 Ohms). High-Speed MOSFET Power Supply. Studio-Grade Bipolar Output Stage Transistors. Fully Adjustable 12dB / Octave Crossover with Differential Circuitry. CH 1 – 6. Low Pass 50Hz – 250Hz. High Pass 50Hz – 250Hz. Full IC-Controlled Protection Circuitry. Fully Adjustable Bass Equalization Control. 2 Ohm Stable Stereo.
• 4 Ohm Mono Bridgeable. 3 Channel Mixed-Mono Capable@ 4 Ohm. 2 CH / 4 CH/ 6 CHInput Mode Selector. Mute and Delay Soft Start System. Remote Dashboard Subwoofer Control. 8 Volt Preamp Circuitry. ELNA Brand Audiophile Quality Capacitors. Status Mode LED Indicator. Frequency Response: 10Hz – 40KHz. Minimum THD at Rated Power: 100dB. Damping Factor: > 200 @ 100Hz. Dual 60 Amp Maxi Fuses.
• Dimensions: (W x H x L) 8.66″ x 2.09″x 16.14″

Features :

• Rockville Rxm-f3 1600 Watt peak/800W RMS Marine class D mono block amplifier.
• Ceja Compliant Power Ratings: 65 watts RMS x 4 channel @4 ohms and 1% THD+N. 85 watts x 4 @ 2 ohms
• Rams power Ratings: 800 watts (4 x 200 watts RMS) @ 2 ohms. 800 watts (2 x 400 watts RMS) @ 4 ohm bridged. 500 watts (4 x 125 watts RMS) @ 4 ohms.
• Peak power: 1600 watts (2 x 800 @ 2 ohms or 1 x 1600 @ 4 ohms). high-speed MOSFET power supply. Studio-grade bipolar output stage transistors.
• Fully adjustable 12Db/ octave Crossover with differential circuitry. Ch3 & Ch4 low Pass 50Hz – 3Khz. Ch3 & Ch4 high Pass 15Hz – 1Khz. Ch1 & Ch2 high Pass 50Hz – 300Hz, 500Hz – 3Khz (X10).
• Crossover Band-Pass control. Fully adjustable 12Db Bass equalizer. 2 ohm stable stereo. 4 ohm mono bridgeable. 3 channel mixed-mono capable.
• Full ice-controlled protection circuitry. Mute and delay soft start system. High level input with smart auto turn-on.
• Full ice-controlled protection circuitry. 2 Ch./ 4 Ch. input mode switch. Rica preamp line output. Lena brand audiophile capacitors.
• 8 Volt preamp circuitry. Status mode LED indicator. Minimum THD at rated power:
• Sensitivity: 100Db @ 1W/ 1M. Damping factor: > 200 @ 100Hz. Three 20 amp maximum fuses. Dimensions: ( w x H x L ) 8.6″ X 2″ X 13.7″.

Features :

• Rockville RPA12 5000 Watt peak/ 1400W RMS 2 channel power amplifier Pro/DJ amp
• Lcd displays volume in DB per channel and operating temperature. 2U rack space. Built in limiter protects your speakers from distortion and clipping. Bridged Mode allows you to combine both channels power into one channel for use with a subwoofer. Stereo mode is perfect for (2) speakers or (4) speakers in a left and right configuration
• Parallel Mode gives you dual mono output signal which is perfect for monitor use when you want all sounds coming out of each speaker instead of a left/right configuration. Built in Crossover switch (bypass, 80 Hz, 160 Hz) allows amp to be used with full range PA speakers, or subwoofer(s). channel a & B clipping LED indicators. Channel a & B separate level controls. Power, Signal, clipping, and protection LED indicators on front of amp. Heavy duty rack mount ears with handles
• Built-in variable high velocity quiet cooling fans. Maximum headroom for 4-ohm and 8-Ohm speakers. Level controls for precise setting and matching of sensitivity. Computer controlled ice protection circuitry against speaker short circuit, Thermal over load, DC over load. User serviceable fuse (15A, 250V). frequency response (bandwidth @ 2VRMS out, @ -3.0dB) 10 Hz – 30 kHz. Thd + noise @ 1kHz full power:
• Input impedance: 10K ohm balanced. Input signal voltage: 660mV – 1.5V. Input sensitivity: 0.7V. Damping factor: ( 100Hz, 10W, 4 ohms): 40.8. Damping factor: (1kHz @ 8 ohm): >400: 1. Effective Damping factor (100Hz, 10W, 4 ohms) 1.08. Output Impedance at speaker terminals: 0.09803 ohms. Frequency response vs THD+N (worst case, across normal bandwidth 1W) 0.11%. signal to noise ratio: > 100dB. Imd 60Hz & 1kHz, 4: 1:
• Class A/B

Features :

• Class D MOSFET Monoblock Power Amplifier
• Peak Power at 1 Ohm: 388 Watts | RMS Power at 1 Ohm: 350 Watts
• Frequency Response: 20Hz – 250Hz, On-board Bass EQ Switch with +6 or +12dB boost at 45Hz
• Featuring 4-Way Protection Circuitry and 8 AWG Power & Ground Input Terminals for Maximum Current Flow
• Stable at 1 ohm | Remote Subwoofer Level Control Included
• Highly Efficient Heatsink Design allows for Maximum Reliability & Performance